Systemic Development > Analog Devices

My new thing. The best thing to start any analog rig...

<< < (2/3) > >>

doug s.:
1 degree slope from outside to center is the biggest +, imo...

doug s.

Folsom:

--- Quote from: doug s. on November 01, 2020, 03:03:15 PM ---1 degree slope from outside to center is the biggest +, imo...

doug s.

--- End quote ---

It matters a lot, but there are damping versions with 1 degree slope and they don't sound good.

doug s.:
i really like the hard composite mat that's included w/my oracle delphi, that has this slope.  i would not use any aftermarket mat w/o this slope, if i could avoid it.

jeremy,
have you ever had experience w/the oyaide composite mat?  it's one of the few i know of that's sloped and affordable. (they also have a spendy metal mat.)

doug s.


--- Quote from: Folsom on November 02, 2020, 07:58:13 PM ---
--- Quote from: doug s. on November 01, 2020, 03:03:15 PM ---1 degree slope from outside to center is the biggest +, imo...

doug s.

--- End quote ---

It matters a lot, but there are damping versions with 1 degree slope and they don't sound good.

--- End quote ---

Folsom:
Yes I know of it, and was specifically steered away. My friend who recommended stainless steel said it sounds bad.

doug s.:
thanks for the tip.  i found a cheap ($25 shipped) mat from an old technics sl-5 that's slightly concave, but not uniformly smooth.  it fits perfectly on my fairchild 411.  i was wondering about something a bit fancier, but i suspect a larger cash outlay than i'm willing to spend would be required.

doug s.


--- Quote from: Folsom on November 05, 2020, 04:59:21 AM ---Yes I know of it, and was specifically steered away. My friend who recommended stainless steel said it sounds bad.

--- End quote ---

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version