Systemic Development > Analog Devices
need help re testing cartridge
steve:
--- Quote from: Nick B on August 06, 2020, 11:12:17 PM ---
--- Quote from: steve on August 06, 2020, 07:53:38 PM ---
--- Quote from: Nick B on August 06, 2020, 06:50:44 PM ---Thanks, Steve. The pdf didn’t display, but I was able to get ohm measurements and they were consistent for each channel. All I had available was a RX1K ohm setting. That Micronta is at least 25-30 years old. Had to clean those leads a bit :)
Nick
--- End quote ---
Hi Nick,
May have to contact Folsom about it, as the .pdf opens for me. I am using Firefox, do you have .pdf or firefox .pdf applications?
I could go .jpg and see how that works.
I used the Rx 200k, much higher ohmage to as to limit the current through the coil and movement of the cantilever.
Below is same diagram in .jpg .
cheers
steve
--- End quote ---
Steve,
I sent my results to the buyer. Will see what he says.
Thanks much,
Nick
--- End quote ---
Your welcome Nick. Glad all worked out for you.
I hope the newbies will save or print out this info for a later time.
cheers and great weekend Nick.
steve
Nick B:
Thanks, Steve. The sale isn’t quite concluded yet. Yes, enjoy your weekend as well. Am enjoying the cooling trend locally.....only 100 degrees today 🥵
Nick
Navigation
[0] Message Index
[*] Previous page
Go to full version