Electro Stimulation Ward > Signals and Noise
Tracking down noise
S Clark:
I had a low level noise in my main system for a good while... couple of years. I thought it was an issue with a tonearm. Looked at finding someone to polish or replace bearings. Over time, the low level noise became more intrusive and sounded like a dirty volume pot in my Dodd pre... only randomly and without the volume being touched. But finally I desoldered and put in a new Alps. It was a pain in the ass, and fortunately Rich H was available to guide me to the correct replacement. But that wasn't it. And then :duh, I decided to replace the 6H30DR tube... success!!! For a day or two.
Time to call the pros. I talked with Charlie Cocci, who has most of the schematics for Dodd gear. We decided to replace a board, and Charlie had an extra on hand to send me. A week later it arrives. The unit is plugged in but the case is off and I start to look at the board. It's got a pin connection that I touch... and the noise appears. I wiggle it again, and the noise appears. I wiggle another pin connection, and the noise appears. I call Charlie, and after a liberal spray of Caig De Oxit and a good scrubbing with a set of brushes for tube sockets, the noise is gone.
A year or two has gone by, and all it really needed was to take the internal connectors loose, clean them, and put them back on.
This has been a hard lesson learned. Corrosion is insidious. Take the case off your gear occasionally and clean all contacts. It will be on my list of annual things to do.
Nick B:
That’s quite an adventure/ordeal and over quite a long period. Glad you had the persistence to get it resolved. How long have you had the Dodd?
S Clark:
--- Quote from: Nick B on September 20, 2021, 07:39:06 PM ---How long have you had the Dodd?
--- End quote ---
Probably 6-7 years. I've got one of his first battery preamps in my other system that I've had since around 2006. They are excellent gear.
malloy:
So, it was dirty and loose pins in the tube sockets?
The amount of troubleshooting you performed is indeed something. To summarize the list of suspects: Tonearm bearings > Volume Pot > noisy tube > new board > pins
This would have made me go mad, but of course, things like these you just cannot 'let go', that is why you are in the hobby.
Reminds me of a smaller ordeal I had after having my amp serviced. One channel would go dead, but of course the fault only showed itself when I was listening and never at the repair shop!
BobM:
I agree that your diligence is commendable. The first, very first thing to do with any troubleshooting problem is to isolate the true source of the noise. To go from a turntable to an amp as the source means you didn't successfully perform that first exercise. Something as simple as identifying that the noise happened on both a turntable and a CD player would confirm that the noise was indeed somewhere after the source component in the chain.
I'm glad you finally found the problem without having to fully replace your amp. I don't know if I would be as successful a sleuth to open it up and check the pins and connections, but that was indeed a stroke of genius. Clean connections ... who would have thought they mattered (sic)? :duh
Navigation
[0] Message Index
[#] Next page
Go to full version