The PI Uberbuss
What is the technology used in Uberbuss?
At the insistence of rollo I just registered here and this looks like as good of a place to get my feet wet as any.
Th UberBUSS is a passive, parallel filtration device that is non-current limiting and uses no coiled inductors in its construction. A simplified description is as follows:
Power inlet (IEC, Neutrik or hard wired)
The Brick - primary EMI/RFI filtration - a proprietary construct
Power Factor Correction - produces more available current under the curve - built from Type 'X' capacitors
FinalFilters - individual high frequency filters on each receptacle
Current throughput capability 40A
All of this is mounted in a non-magnetic, non-metallic enclosure. I have found this to be very important to eliminate eddy currents that will color the SQ.
Standard receptacles are modified Pass & Seymour 5362A receptacles with no magnetic components and are cryogenically treated for lowest noise and conductivity.
I developed these units for use in recording studios after auditioning available units that frankly speaking didn't sound very good or dramatically blunted transients.
It is an easy solution that was hard to figure out.
Dave