I’ve been in this hobby for 35+ years and it’s only the last few years where I’ve been able to get very good sound and “dial in” my system. Most of that has been accomplished by listening to guys here who are smarter and more experienced in audio than me. As I continue to get improved sound, I’ve adopted a general philosophy of using a tube preamp, a solid state amp, excellent AC filtration and using looms of power cords and cables. I’ve learned quite a bit about tube rolling and the huge difference it can make simply by trying different 6ns7 nos tubes and 5u4c and variant rectifier tubes. For years I had harsh upper mids, partly due to listening to bad recordings, not having any room treatments and less than stellar wires. Nowadays, I lean toward the warm side of neutral. I only want to voice my system based on the preamp tubes that I use. I don’t want to get into mixing and matching different brands of power cords and cables to fix problems. Either the power cords and cables work in unison to present the music properly or they don’t. I realize this can get a bit pricey going with one company’s power cords or cables, but it makes the most sense to me and is a simpler methodology to evaluate. Admittedly, I rely on some reviews in addition to members opinions and experience here. If there’s a question of a speaker, amp, dac etc being described as on the lean side, I will likely avoid it. So I’m wondering what methodologies and practices you’ve employed to dial in your system or is it more flexible and desirable to mix and match.
Is not this fun Nick? Just kidding. Get's pretty expensive, time consuming, and sometimes frustrating.
One can only do what one can do.
I have a particular philosophy I adhere to.
1. My goal is a perfect audio system. By perfect I mean hearing what is recorded. The result is stunning on
many selections.
2. I don't want power cords, fuses, power transformers, rectifier tubes to affect the musical quality.
Allowing such parts to manipulate the sound does give one variables to deal with, but also degrades
the overall maximum musical quality one is able to obtain. I realize $ can be a limitation for anyone. I
spent gobs of money in R&D, so I understand.
To isolate said parts listed requires robust power supply filtering stages, as well as proper quality and
size values of parts.
3. I do a preliminary of the room acoustics, minimizing huge nodes.
4. I want to mate wires, plugs, jacks, and other parts for minimum interactions and distortion.
5. Once all the components, parts, once the system is accurate, I once again deal with the room acoustics.
Why? Because once the system is accurate, then one can relatively compare how much damage the
components cause VS how much damage the room causes.
What I found was the components, even parts are just as bad as the room in terms of damaging the music,
if not more. How can that be? It has something to do with bandwidth of the mode/frequency abnormality.
A. Many of the nodes created by the room are 1/3 octave or less in bandwidth. According to RANE, those
tend to be not noticed even though several db deep/raised.
B. Although the +/- frequency response deviation of each components are less, the deviations cover the entire
audio band, many many octaves. A slight tweak in the highs affects the deepest bass and visa versa due
to changing all the harmonics vs the fundamental frequencies.
There are also other problems such as spacial characteristics, grunge, inter-modulation distortion, etc.
I would suggest the most Difficult problem to correct in a room are the low frequency modes in a room.
That can take lot of time and efforts to minimize.
That is what I did to obtain excellent musical quality.
With that said, typically I would obtain and keep the best sound quality component "A" and exchange the least
quality component "B" for better, even if "B" component is the most expensive. I have seen over and
over someone who rids the best quality component because they did not want to rid of "B" component that
was more expensive. Not the way to go in the long run.
Cheers
steve