Author Topic: can some damaged tubes be revitalized  (Read 935 times)

Online Nick B

  • Global Moderator
  • *****
  • Posts: 3397
can some damaged tubes be revitalized
« on: March 30, 2020, 07:25:51 PM »
Saw this on YouTube. I wasn’t aware this was possible. Comments, pls

https://www.youtube.com/watch?v=Uv0D1-2cVg0
Van Alstine SET 120 Control Amp
Supratek Chardonnay preamp
Fritz Carrera 7 BE speakers
Border Patrol SEi dac
iFi Zen Stream & Mojo Audio lps
Wywires cables & Audio Envy power cords
Roon, Tidal, Qobuz
PI Audio UberBUSS

Offline steve

  • Audiologist
  • *
  • Posts: 1013
Re: can some damaged tubes be revitalized
« Reply #1 on: March 31, 2020, 07:05:14 AM »
Yes Nick it is possible for Thoriated Tungsten cathodes, depending upon how much thorium is left in the interior cathode tungsten filament. IF I remember correctly, with no plate voltage, run the filament 20% above normal for a few minutes. Repeat as necessary. The thorium will "boil" to the surface and emission will increase, if there is thorium left.

The only oxide cathodes I have ever seen improve is in picture tubes. There are usually several stages of a picture tube rejuvenator one can try. The highest stage actually causes sparks inside the tube, ripping off the outer layer of oxide material from the cathode so fresh material is now on the surface. Sometimes it works, sometimes it ripped off all the material, or what was left.

cheers

steve

Steve Sammet (Owner/Designer, SAS Audio Labs, Ret)
SAS "V" 39pf/meter 6N Copper ICs,
SAS Test Phono Stage
Acutex 320 iii STR Moving Iron Cartridge
SAS 11A Perfect Tube Preamplifier
SAS 25 W Near Perfect Triode/UL Monoblocks
2 way Floor Standing Test Spk